1970 Chevy El Camino

This 1970 El Camino is fully optioned – it has power windows, power wing vents, air conditioning, a big block with a 4-speed. Originally it was gold but was repainted black at some point in its history. We’re fixing some wiring that burnt out.

1969 Chevy Camaro

We’re working on getting this 1969 Chevy Camaro to run, then we’re going to do some rust repair here and there on the body of the car.

1969 Chevy Truck

We took this truck apart and are going to do a 5.3 LS overdrive motor conversion, along with upgrading the transmission. We’re also updating the gauges and wiring.

1951 Chevy Truck

The owner of this truck originally wanted Full Scale to do the work, but we didn’t have the capacity at the time to take the project on. The owner ended up having someone else build the truck for him, and brought it in to us later on to improve upon a few things, including the gauges and wiring under the …

1965 Chevy Stepside Truck

This 1965 Chevy Stepside Truck came into our shop to have a new grill put in, and to have the doors rebuilt along with having new weather stripping installed. We also pulled out the old wooden bed and are putting in a new, high-end finished bed back in it.

2018 Chevy LT1 Camaro

This car was pushing ~670 hp at the rear wheels, but the owner wanted to ramp it up a bit. We ended up pulling the motor and transmission out, and Kenny Duttweiler rebuilt the motor and put forged components in it. Then we reassembled the car and upgraded the clutch. Now this Camaro is seeing ~800 hp at the rear …

1955 Chevy

The owner of this 1955 Chevy has owned it since 1978, buying it right out of high school. It’s an original 4-door 150 sedan with the original 6-cylinder engine in it. In the past, we’ve done a disc brake and wiper conversion. This time around, we’re flushing the cooling system and rebuilding the carburetor. We’re also having the water pump …

1968 Chevy Camaro SS

This 1968 Chevy Camaro SS is getting some new wheel bearings and seals in the front, along with new brake pads. The rear is also getting new axles, bearings and seals. We’ve done some work on this car in the past – about 6 months ago, we put a new 383 engine in it The owner is interested in taking …

1950 Chevy

This 1950 Chevy is in the shop to have some new brake lines installed. The owner of this drag car has been building it for the past 25 years. We’re also going to be fitting the windows to the fiberglass doors. Currently the doors are just bare shells, so we need to install the internal door components to get the …

1965 Chevy C10 Truck

This 1965 short bed Chevy Truck is in the shop for some fabrication work. We’re going to fabricate all the brackets, and wire in the electrical harnesses and computer for the motor. This kind of work needs to be done before the body work and paint is done. After we finish welding some brackets to the firewall and whatnot, this …